Configuring FXS Port

If you want to see where the FXS Card is installed
do a sh diag
Below is an example of the output of BRI card , it shows that the slot used is 0 the same can be applied for the FXS port

WIC Slot 0:
VIC2 - BRI-NT/TE Voice daughter card (2 port)

Configuring the FXS port

2821-Router#conf t
2821-Router(config)#voice-port 0/0/0
!!decide the tone used in your country
2821-Router(config-voiceport)#cptone fr
!!give a description
2821-Router(config-voiceport)#description Jack Main line
!!This is the name it will appear for other people when you call them using this fxs port
2821-Router(config-voiceport)#station-id name Jack Brown
!!This is the number it will appear for other people when you call them using this fxs port
2821-Router(config-voiceport)#station-id number 5001
!! use loop-start if you are pluging an analog phone or fax
!!use ground-start if you are connecting to another PBX
2821-Router(config-voiceport)#signal loopStart

Next step is to configure dial-peer allowing incoming calls

2821-Router(config)#dial-peer voice 10 pots
!!whenever any one try to reach 5001 then this pattern will be used
2821-Router(config-dial-peer)#destination-pattern 5001
!!define the desired port
2821-Router(config-dial-peer)#port 0/0/0

Advertisements
This entry was posted in CallManager, CallManager Express, Gateway and tagged , . Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s